Suzuki GA413 Service Manual page 716

10B-22 AIR BAG SYSTEM
DTC B1015 – PASSENGER AIR BAG INITIATOR CIRCUIT RESISTANCE HIGH
DTC B1016 – PASSENGER AIR BAG INITIATOR CIRCUIT RESISTANCE LOW
DTC B1018 – PASSENGER AIR BAG INITIATOR CIRCUIT SHORT TO GROUND
DTC B1019 – PASSENGER AIR BAG INITIATOR CIRCUIT SHORT TO POWER
CIRCUIT
1. From main fuse
2. Ignition switch
3. "AIR BAG" fuse in fuse box
4. SDM
5. Passenger air bag (inflator) module
6. Ground for air bag system
CAUTION:
D Be sure to perform AIR BAG DIAGNOSTIC SYSTEM CHECK before starting diagnosis according
to flow table.
D When measurement of resistance or voltage is required in this table, use a tester along with a cor-
rect terminal adaptor from special tool (Connector test adapter kit).
D When a check for proper connection is required, refer to INTERMITTENT AND POOR CONNEC-
TIONS in this section.
D If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
DTC WILL SET WHEN:
DTC B1015: The combined resistance of the passenger air bag (inflator) module, harness wiring and connector
terminal contact is above a specified value for specified time.
DTC B1016: The combined resistance of the passenger air bag (inflator) module, harness wiring and connector
terminal contact is below a specified value for specified time.
DTC B1018: The voltage measured at passenger air bag initiator circuit is below a specified value for specified
time.
DTC B1019: The voltage measured at passenger air bag initiator circuit is above a specified value for specified
time.
TABLE TEST DESCRIPTION:
DTC B1015, B1016, B1018 and B1019:
STEP 1:Check whether malfunction is in passenger air bag (inflator) module.
STEP 2:Check passenger air bag (inflator) module initiator circuit in air bag harness.
STEP 3:Check passenger air bag (inflator) module initiator circuit in air bag harness. (for DTC B1019 only)