6H-6 CHARGING SYSTEM
1. Rotor
1. Rotor
1. Stator
2. Stator lead
INSPECTION
Rotor
1) Using ohmmeter, check for continuity between slip rings of ro-
tor. If there is no continuity, replace rotor.
Standard resistance: 2.3 – 2.7 W
2) Using ohmmeter, check that there is no continuity between slip
ring and rotor core. If there is continuity, replace rotor.
3) Check slip rings for roughness or scoring. If rough or scored, re-
place rotor.
Stator
1) Using ohmmeter, check all leads for continuity.
If there is no continuity, replace stator.
1. Stator
2) Using ohmmeter, check that there is no continuity between coil
leads and stator core. If there is continuity, replace stator.
Brush and brush holder
Check each brush for wear by measuring its length.
If brush is found worn down to service limit, replace brush.
Brush length "a"
Standard:
Service limit: 2 mm (0.08 in.)
16 mm (0.63 in.)