Brake Back Plate - Suzuki GA413 Service Manual

1. Stopper ring

2. Brake back plate

5) Install brake shoes, referring to steps 1) to 3) of BRAKE SHOE
INSTALLATION.
6) Install brake drum. (Refer to steps 1) and 2) of BRAKE DRUM
INSTALLATION of this section.
7) Fill reservoir with brake fluid and bleed brake system. (For
bleeding operation, refer to BLEEDING BRAKES.)
8) Upon completion of all jobs, turn adjuster upward by flat-head
screw driver and depress brake pedal with about 30 kg (66 lbs)
load three to five times so as to obtain proper drum-to-shoe
clearance.
Adjust parking brake cable. (For adjustment, refer to PARK-
ING BRAKE CHECK AND ADJUSTMENT.)
9) Install console box.
10) Install wheel and tighten wheel nuts to specified torque. (Refer
to TIGHTENING TORQUE SPECIFICATIONS.)
11) Check to ensure that brake drum is free from dragging and
proper braking is obtained. Then remove vehicle from hoist
and perform brake test (foot brake and parking brake).
12) Check each installed part for oil leakage.
BRAKE BACK PLATE
REMOVAL
1) Perform steps 1) to 6) of BRAKE DRUM REMOVAL.
2) Perform steps 2) to 4) of BRAKE SHOE REMOVAL.
3) Perform steps 3) to 4) of WHEEL CYLINDER REMOVAL.
4) Remove parking brake cable from brake back plate by squeez-
ing parking brake cable stopper ring.
5) Drain rear differential gear oil.
6) Remove brake back plate bolts.
7) Draw out rear axle shaft with brake back plate, refer to REAR
AXLE SHAFT REMOVAL in Section 3E.
8) Remove wheel bearing, refer to WHEEL BEARING REMOVAL
in Section 3E.
9) Remove brake back plate from axle shaft.
1. Brake back plate
2. Plate bolt
INSTALLATION
1) Install brake back plate to axle shaft.
2) Press-fit wheel bearing and retainer ring, refer to WHEEL
BEARING INSTALLATION in Section 3E.
BRAKES 5-43