Suzuki GA413 Service Manual page 175

1. Shock absorber lower mounting bolt and nut
2. Parking brake cable
3. Wheel speed sensor lead wire clamps
4. Trailing arm
5. Trailing arm mounting bolt and nut
1. Trailing arm
2. Trailing arm mounting bolts
3. Wheel speed sensor lead wire clamps
4. Parking brake cable
5. Shock absorber lower mounting nut
TRAILING ARM (COIL SPRING TYPE)
REMOVAL
1) Hoist vehicle and remove rear wheel.
2) Support rear axle housing by using floor jack.
CAUTION:
Never apply floor jack against lateral rod as it may get
deformed.
3) Remove shock absorber lower mounting bolt and nut.
4) Remove brake drum and brake shoe and disconnect parking
brake cable from brake back plate, refer to PARKING BRAKE
CABLE REMOVAL of Section 5.
5) For ABS equipped vehicle, disconnect wheel speed sensor
lead wire clamps from trailing arm.
6) Remove trailing arm mounting bolts and nuts.
INSTALLATION
1) Install trailing arm to vehicle body and rear axle housing, refer-
ring to figure for proper installing direction of bolts.
NOTE:
Nut and bolts should not be tightened.
2) Install wheel speed sensor lead wire clamp, if equipped.
3) Connect parking brake cable to brake back plate and install
brake shoe and brake drum, refer to PARKING BRAKE CABLE
INSTALLATION of Section 5.
4) Install shock absorber to rear axle housing.
NOTE:
Nut and bolts should not be tightened.
5) Remove floor jack from rear axle housing.
6) Install wheel and tighten wheel nuts to specified torque.
Tightening Torque for wheel nuts
85 N·m (8.5 kg-m, 61.5 lb-ft)
7) Lower hoist and vehicle in non loaded condition, tighten trailing
arm mounting bolts and nuts and shock absorber lower mount-
ing nut to specified torque.
Tightening Torque
(a): 80 N·m (8.0 kg-m, 58.0 lb-ft)
REAR SUSPENSION 3E-11