Suzuki GA413 Service Manual page 625

1. Fuel pump assembly
2. Fuel level gauge  terminal
3. Fuel level gauge terminal
4. Float
FUEL METER/FUEL GAUGE UNIT
FUEL LEVEL METER
INSPECTION
1) Remove combination meter, refer to combination meter in this
2) Connect battery terminals to combination meter terminals as
3) Check that the fuel level meter operates as shown.
1. Combination meter
2. Fuel meter
FUEL SENDER GAUGE
INSPECTION
Remove fuel pump assembly referring to Section 6C of this manu-
al.
Use an ohmmeter to confirm that resistance of sender gauge
unit changes with change of float position.
Full Upper "a"
Middle (1/2) "b"
Full Lower "c"
If the measured value is out of specification, replace.
section.
shown.
Terminal (a)
open
To negative battery terminals
If not, replace fuel level meter.
Float Position
103.7 mm (4.08 in.)
153.9 mm (6.06 in.)
218.1 mm (8.59 in.)
BODY ELECTRICAL SYSTEM 8-23
meter indicates
"E" position
"F" position
Resistance (W)
2 - 4
29.5 - 35.5
119 - 121