Suzuki GA413 Service Manual page 1082

4A-4 FRONT DRIVE SHAFT
A: Undo caulking
3. Suspension control arm
ON-VEHICLE SERVICE
DRIVE SHAFT ASSEMBLY
REMOVAL
1) Undo caulking and remove drive shaft nut (1) and washer.
2) Hoist vehicle and remove wheel.
3) Drain front differential oil.
4) Remove E-ring (1).
5) Remove brake caliper carrier (2), with caliper (3).
NOTE:
Hang removed caliper with a wire hook or the like so as to
prevent brake hose from bending and twisting excessive-
ly or being pulled.
Don't operate brake pedal with pads removed.
6) Remove tie-rod end nut (1).
7) Disconnect tie-rod end (2) from steering knuckle (3) using spe-
cial tool.
Special Tool
(A): 09913-65210
8) Remove arm joint bolt (1) and disconnect suspension control
arm ball stud from steering knuckle (2).
9) Remove strut bracket bolts (1).
10) Remove steering knuckle (2).