Suzuki GA413 Service Manual page 734

10B-40 AIR BAG SYSTEM
1. Yellow connector of passenger air bag (inflator) module
(if equipped)
2. Steering support member
3. Harness cover
3) If equipped with passenger air bag (inflator) module, connect
Yellow connector of passenger air bag (inflator) module, and be
sure to lock connector with lock lever.
i) Connect connector.
ii) Lock connector with lock lever.
4) Install glove box.
5) Install "AIR BAG" fuse to fuse box.
6) Turn ignition switch to ON position and verify that "AIR BAG"
warning lamp flashes 6 times and then turns OFF.
If it does not operate as described, perform AIR BAG DIAG-
NOSTIC SYSTEM CHECK in this section.
HANDLING AND STORAGE
SDM
WARNING:
Never power up air bag system when SDM is not rigidly
attached to the vehicle. Otherwise, personal injury may
result.
CAUTION:
After detecting one time of such collision as to meet de-
ployment conditions, the SDM must not be used.
Refer to AIR BAG DIAGNOSTIC SYSTEM CHECK when
checking the SDM.
D Never attempt disassembly of SDM.
D When storing SDM, select a place where neither high tempera-
ture nor high humidity is anticipated and oil, water and dust are
kept off.
D If SDM was dropped from a height of 90 cm (3 ft) or more or if
it is found to be damaged or deformed, replace it with a new one.
D If installation part of SDM was damaged, repair that part com-
pletely before reinstallation.
D All SDM and mounting bracket fasteners must be carefully
torqued and the arrow must be pointed toward the front of the
vehicle to ensure proper operation of the air bag system.
1. SDM