Suzuki GA413 Service Manual page 705

1. Data link connector (DLC)
1. "AIR BAG" warning lamp
2. "AIR BAG" monitor coupler
3. Diagnostic switch terminal
4. Air bag harness (covered yellow tube)
EXAMPLE: When driver air bag initiator circuit resistance high (DTC B1021) is set
Turn ON
Turn OFF
DTC CHECK
Using SUZUKI scan tool
1) Turn ignition switch to OFF position.
2) After setting cartridge to SUZUKI scan tool, connect it to data
3) Turn ignition switch to ON position.
4) Read DTC according to instructions displayed on SUZUKI scan
5) After completing the check, turn ignition switch to OFF position
Not using SUZUKI scan tool
1) Check that malfunction indicator lamp ("AIR BAG" warning
2) Using service wire, ground diagnosis switch terminal in monitor
3) Read DTC from flashing pattern of malfunction indicator lamp
4) After completing the check, turn ignition switch to OFF position
1.0 3.0
0.3
0.3
link connector (DLC) located on underside of instrument panel
at driver's seat side.
Special Tool
(A): 09931-76011 (SUZUKI scan tool)
(B): Mass storage cartridge
(C): 09931-76030 (16/14 pin DLC cable)
tool and print it or write it down. Refer to SUZUKI scan tool oper-
ator's manual for further details.
and disconnect SUZUKI scan tool from data link connector
(DLC).
lamp) comes ON when ignition switch is turned to ON position.
If it does not come "ON", proceed to TABLE B.
coupler.
("AIR BAG" warning lamp). (Refer to DTC TABLE.)
and disconnect service wire from "AIR BAG" monitor coupler.
AIR BAG SYSTEM 10B-11
3.0