Suzuki GA413 Service Manual page 1069

3D1-12 FRONT SUSPENSION (4WD)
1. Strut support cap
2. Strut nut
3. Strut lock washer 10. Spring seat
4. Strut rebound stopper 11. Bump stopper
5. Strut support 12. Coil spring
6. Strut rubber support 13. Strut assembly
7. Strut bearing seat
1. Strut bracket nut 3. E-ring
2. Strut support nut 4. Bracket end surface
D Install bump stopper (11) onto strut rod. Refer to the left figure for
D Clean strut bearing (8) and install it on spring upper seat (9). Refer
D Wash bearing seat (7) and install it as shown.
D On bearing seat, install rebound stopper (4), strut support (5) and
D Recheck that stepped part of spring seat (9) and spring end (12)
8. Strut bearing
9. Spring upper seat
INSTALLATION
1) Install strut by reversing removal procedure. Insert bolts in such
2) Torque all fasteners to specification.
installing direction.
to figure at left for installing direction.
rubber support (6) in this sequence. Refer to the figure for instal-
ling directions. Tighten strut nut (2) to specified torque and then
apply water-proof coating (paint or lacquer) all around nut and
strut rod screw part.
NOTE:
As shown at the left, have sections "A" and "B" of strut sup-
port rubber caught by strut support securely.
Tightening Torque
.
(a): 50 N m (5.0 kg-m, 36.5 lb-ft)
are in place to each other as described.
a direction as shown.
Tightening Torque
.
(a): 73 N m (7.3 kg-m, 53.0 lb-ft)
.
(b): 95 N m (9.5 kg-m, 69.0 lb-ft)
NOTE:
Don't twist brake hose when installing it.
Install E-ring as far as it fits to bracket as shown.