Suzuki GA413 Service Manual page 202

5-6 BRAKES
MASTER CYLINDER ASSEMBLY
GENERAL DESCRIPTION
The master cylinder has two pistons and three piston cups. Its hydraulic pressure is produced in the primary ("a"
in the figure below) and secondary ("b") chambers. The hydraulic pressure produced in the primary chamber ("a")
acts on the rear wheel brakes (front wheel brakes for vehicle with ABS).
Also, the hydraulic pressure produced in the secondary chamber ("b") acts on the front wheel brakes (rear wheel
brakes for vehicle with ABS).
CAUTION:
Replace all components included in repair kits to service this master cylinder. Lubricate rubber parts
with clean, fresh brake fluid to ease assembly. Do no use lubricated shop air on brake parts as dam-
age to rubber components may result. If any hydraulic component is removed or brake line discon-
nected, bleed the brake system. The torque values specified are for dry, unlubricated fasteners.
[A]
[B]
[A] : For vehicle without ABS
[B] : For vehicle with ABS
1. Piston stopper circlip
2. Piston stopper
3. Cylinder cup
4. Plate
5. Primary piston
6. Piston cup
7. Primary piston return spring
8. Primary spring retainer
9. Secondary piston pressure cup
10. Secondary piston
11. Return spring secondary seat
12. Secondary piston return spring
13. Secondary piston stopper bolt
14. Master cylinder body