Suzuki GA413 Service Manual page 178

3E-14 REAR SUSPENSION
10) Break with a chisel the thin ground retainer ring, and it can be
11) Using special tools, remove bearing from shaft and then re-
12) Remove stud bolts by using hydraulic press.
1. Stud bolt
2. Hydraulic press
INSTALLATION
1) Aligning serrations between new stud bolt(s) and flange, install
1. Stud bolt
2. Nut
3. Washer
4. Flange of axle shaft
removed.
move brake back plate.
Special Tool
(C): 09927-18411
(D): 09921-57810
new stud bolt(s) by tightening nut as shown.