Suzuki GA413 Service Manual page 717

DIAGNOSTIC FLOW TABLE
DTC B1015:
STEP
1 1) With ignition switch OFF, disconnect passen-
ger air bag (inflator) module connector be-
hind the glove box.
2) Check proper connection to passenger air
bag (inflator) module at terminals in "D" con-
nector.
3) If OK then connect Special Tool (B) to pas-
senger air bag (inflator) module connector
disconnected at the step 1).
4) With ignition switch ON, is DTC B1015 cur-
rent?
2 1) With ignition switch OFF, disconnect SDM.
2) Check proper connection to SDM at termi-
nals "A7" and "A8".
3) If OK then measure resistance between "A7"
and "A8" terminals with connected Special
Tool (B).
4) Is resistance 4.5 W or less?
Fig. for STEP 1 and 2
Special Tool
(A): 09932-76010
(B): 09932-75010
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (Refer to DTC CLEARANCE), if any.
3) Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.
ACTION YES
Go to step 2.
Substitute a known-good
SDM and recheck.
Fig. for STEP 2
AIR BAG SYSTEM 10B-23
NO
1) Ignition switch OFF.
2) Replace passenger
air bag (inflator) mod-
ule (Refer to PAS-
SENGER AIR BAG
(INFLATOR) MOD-
ULE in this section).
Repair high resistance or
open in "Y" or "Y/R" wire
circuit.