Suzuki GA413 Service Manual page 287

1. Water pipe
2. Stabilizer
3. Right front wheel speed sensor coupler
1. Front wheel speed sensor
2. Clamp bolt
3. Clamp screw
1. Sensor terminal
2. Sensor body
1. Sensor bolt
2. Clamp bolt
3. Clamp screw
REMOVAL
1) Disconnect negative cable from battery.
2) Disconnect front wheel speed sensor coupler.
3) Hoist vehicle and remove wheel.
4. Left front wheel speed 4) Remove harness clamp bolts and clamp screws and remove
sensor coupler
SENSOR INSPECTION
D Check sensor for damage.
D Check sensor for resistance and continuity.
INSTALLATION
1) Check that no foreign material is attached to sensor and rotor.
2) Install it by reversing removal procedure.
3) Check that there is no clearance between sensor and knuckle.
ANTILOCK BRAKE SYSTEM (ABS) (OPTIONAL) 5E-33
front wheel speed sensor from knuckle.
CAUTION:
D Do not pull wire harness when removing front
wheel speed sensor.
D Do not cause damage to surface of front wheel
speed sensor and do not allow dust, etc. to enter its
installation hole.
Between both terminals of sensor : 1.2 – 1.6 kW at 205C
(685F)
Between sensor terminal and sensor body: No continuity
If the check result is not as specified and any malcondition is
found, replace.
Tightening Torque
(a): 26 N·m (2.6 kg-m, 18.8 lb-ft)
(b): 11 N·m (1.1 kg-m, 8.0 lb-ft)
CAUTION:
Do not pull wire harness or twist more than necessary
when installing front wheel speed sensor.