Suzuki GA413 Service Manual page 1077

3D1-20 FRONT SUSPENSION (4WD)
1. Suspension frame bolts
2. Steering gear case bolts
INSTALLATION
1) Install suspension frame and tighten suspension frame bolts to
specified torque.
Tightening Torque
.
(a): 95 N m (9.5 kg-m, 69.0 lb-ft)
2) Install wheel speed sensor harness clamp bolts and clamps to
suspension frame (if equipped with ABS).
3) Install front differential referring to SECTION 7E.
4) Install steering gear case mount bolts and tighten bolts to speci-
fied torque.
Tightening Torque
.
(b): 25 N m (2.5 kg-m, 18.0 lb-ft)
5) Install suspension control arms (right & left), refer to Steps 2) to
6) of SUSPENSION CONTROL ARM INSTALLATION in this
section.
6) Confirm front end (wheel) alignment, refer to SECTION 3A.