Suzuki GA413 Service Manual page 297

ENGINE DIAGNOSTIC FLOW TABLE
Refer to the following pages for the details of each step.
STEP
1 Customer Complaint Analysis
1) Perform customer complaint analysis.
Was customer complaint analysis performed?
2 Diagnostic Trouble Code (DTC) Check, Record and
Clearance
1) Check for DTC. Refer to "DTC Check" in Section 6E.
Is there any malfunction DTC(s)?
3 Visual Inspection
1) Perform visual inspection. Refer to "Visual Inspection"
in this section.
Is there any faulty condition?
4 Visual Inspection
1) Perform visual inspection. Refer to "Visual Inspection"
in this section.
Is there any faulty condition?
5 Trouble Symptom Confirmation
1) Confirm trouble symptom. Refer to the "Trouble Symp-
tom Confirmation" in this section.
Is trouble symptom identified?
6 Rechecking and Record of DTC
1) Recheck for DTC. Refer to "DTC Check" in Section 6E.
Is there any DTC(s)?
7 Rechecking and Record of DTC
1) Recheck for DTC. Refer to "DTC Check" in Section 6E.
Is there any malfunction DTC(s)?
8 Engine Basic Inspection and Engine Diagnosis Table
1) Check and repair according to "Engine Basic Inspec-
tion Flow Table" and "Engine Diagnosis Table" in this
section.
Are check and repair complete?
9 Trouble shooting for DTC
1) Check and repair according to applicable DTC diag.
flow table in Section 6E.
Are check and repair complete?
10 Check for Intermittent Problems
1) Check for intermittent problems. Refer to "Check for
Intermittent Problem" in this section.
Is there any faulty condition?
11 Final Confirmation Test
1) Clear DTC if any.
2) Perform final confirmation test. Refer to "Final Con-
firmation Test" in this section.
Is there any problem symptom, malfunction DTC or abnor-
mal condition?
ACTION YES
Go to Step 2.
1) Print DTC or
write it down and
clear it. Refer to
"DTC Clearance"
in Section 6E.
2) Go to Step 3.
1) Repair or replace
malfunction part.
2) Go to Step 11.
Go to Step 6.
Go to Step 9.
Go to Step 11.
1) Repair or replace
malfunction
part(s).
2) Go to Step 11.
Go to Step 6.
ENGINE 6-5
NO
Perform customer
complaint analysis.
Go to Step 4.
Go to Step 5.
Go to Step 8.
Go to Step 7.
Go to Step 8.
Go to Step 10.
1) Check and repair
malfunction
part(s).
2) Go to Step 11.
Go to Step 11.
End.