Suzuki GA413 Service Manual page 656

9-20 BODY SERVICE
1. Molding (Upper, right and left)
2. Adhesive
3. Glass
4. Spacer
6) Using new brush, apply sufficient amount of primer for glass
along glass surface to be adhered to body.
NOTE:
D Be sure to refer to maker's instruction for proper han-
dling and drying time.
D Do not apply primer on outside of ceramic coated sur-
face.
D Do not touch primer coated surface.
1. Molding
2. Spacer
Width "a": Approx. 20 mm (0.78 in.)
7) Apply adhesive referring to figure at the left.
NOTE:
D Start from bottom side of glass.
D Be careful not to damage primer.
D Apply specified amount of adhesive as given.
Width "e"
Height "f"
Clearance "g" : Approx. 10 mm (0.39 in.)
D Press glass against body quickly after adhesive is ap-
plied.
D Use of rubber sucker grip is helpful to hold and carry
glass after adhesive is applied.
D Perform step 7) to 9) within 10 min. to ensure sufficient
adhesion.
D Be sure to refer to adhesive maker's instruction for
proper handling and drying time.
"b": Approx. 15 mm (0.59 in.)
"c": Approx. 18 mm (0.70 in.)
: Approx. 8 mm (0.31 in.)
: Approx. 14 mm (0.55 in.)