Suzuki GA413 Service Manual page 920

6E-28 ENGINE AND EMISSION CONTROL SYSTEM
4. Turn TP sensor after fitting and align holes
REMOVAL
1) Disconnect battery negative cable at battery.
2) Disconnect connector from TP sensor.
3) Remove TP sensor from throttle body.
INSTALLATION
1) Install TP sensor (1) to throttle body.
Fit TP sensor to throttle body in such way that its holes (3) are
a little away from TP sensor screw holes (2) and turn TP sensor
clockwise so that those holes align.
Tightening Torque
.
(a): 2.0 N m (0.20 kg-m, 1.5 lb-ft)
2) Connect connector to TP sensor securely.
3) Connect battery negative cable to battery.
INTAKE AIR TEMPERATURE SENSOR (IAT SENSOR)
REMOVAL
1) Disconnect battery negative cable at battery.
2) Disconnect connector from IAT sensor (1).
3) Remove IAT sensor (1) from air cleaner case (2).
INSPECTION
Immerse temperature sensing part of IAT sensor in water (or ice)
and measure resistance between sensor terminals while heating
water gradually.
If measured resistance doesn't show such characteristic as shown
in left figure, replace IAT sensor.