Suzuki GA413 Service Manual page 1084

4A-6 FRONT DRIVE SHAFT
2
DISASSEMBLY
NOTE:
Do not disassemble wheel side joint (outboard joint). If any
malcondition is found in any joint, replace it as assembly.
For DOJ type drive shaft (Differential side)
1) Remove boot band (1) of differential side joint.
2) Slide boot (1) toward the center of shaft and remove snap ring
(2) from outer race, then take shaft out of outer race (3).
3) Wipe off grease and remove circlip (1) used to fix cage by using
special tool (A).
Special Tool
(A): 09900-06107
4) Remove draw away cage (1), and remove boot (2) from shaft.
If cage is hard to remove, use puller (3).
3
INSPECTION
D Inspect boots for breakage or deterioration.
Replace them as necessary.
D Inspect circlip, snap ring and boot bands for breakage or de-
formation. Replace as necessary.