Suzuki GA413 Service Manual page 1065

3D1-8 FRONT SUSPENSION (4WD)
1. Compression rod lock nut
2. Compression rod stud nuts
1. Compression rod bracket bolts
5, (b), *
* : Use new nut
1. Compression rod bracket 5. Compression rod lock nut
bolts 6. Compression rod stud nuts
2. Compression rod bracket 7. Compression rod
3. Compression rod bushings 8. Suspension control arm
4. Compression rod washer 9. Compression rod front
COMPRESSION ROD AND/OR BUSHINGS
REMOVAL
1) Hoist vehicle, allow front suspension to hang free.
2) Remove stabilizer bar, refer to STABILIZER BAR AND/OR
3) Remove compression rod nuts (1, 2).
4) Remove compression rod (3).
3. Compression rod
4. Suspension arm
5) Remove compression rod bracket (2) from vehicle body.
INSTALLATION
Install in reverse order of removal procedure, noting the following
points.
D For correct installation of compression rod bushings and com-
pression rod washers, refer to the left figure.
D Use new compression rod lock nuts.
D Tighten each bolts and nuts to specified torque.
Tightening Torque
(a): 55 N
(b): 65 N
(c): 95 N
washer
BUSHINGS REMOVAL.
.
m (5.5 kg-m, 40.0 lb-ft)
.
m (6.5 kg-m, 47.0 lb-ft)
.
m (9.5 kg-m, 69.0 lb-ft)