Suzuki GA413 Service Manual page 1041

0B1-6 MAINTENANCE AND LUBRICATION (4WD)
3) Check belt (1) for tension.
A/C compressor drive belt tension
"b": 8 – 9 mm (0.32 – 0.35 in.) deflection under 100 N
4) If belt tension is out of above specification, adjust it by adjusting
compressor position.
Tightening Torque for compressor mounting bolts
23 N
5) Connect negative cable at battery.
1. Drive belt
2. Crankshaft pulley
3. A / C compressor
ITEM 1-2
Camshaft Timing Belt Replacement
Replace timing belt. Refer to TIMING BELT AND BELT TENSION-
ER in SECTION 6A.
ITEM 1-3
Valve Lash Inspection
1) Remove cylinder head cover.
2) Inspect intake and exhaust valve lash and adjust as necessary.
Refer to VALVE LASH (CLEARANCE) in SECTION 6A for valve
lash inspection and adjustment procedure.
3) Install cylinder head cover and tighten bolts to specification.
Refer to CYLINDER HEAD COVER in SECTION 6A for the de-
tails.
(10 kg, 22 lb) pressure.
.
m (2.3 kg-m, 16.5 lb-ft)
(Coolant tempera-
ture is 15 – 25_C
Valve lash
(g (gap "a") )
specifica- 0.13 – 0.17 mm
Intake
tion (0.005 – 0.007 in.)
0.23 – 0.27 mm
Exhaust
(0.009 – 0.011 in.)
When cold When hot
(Coolant tempera-
ture is 60 – 68_C
or 59 – 77_F) or 140 – 154_F)
0.17 – 0.21 mm
(0.007 – 0.008 in.)
0.27 – 0.31 mm
(0.011 – 0.012 in.)