Suzuki GA413 Service Manual page 594

Right side
Right side
1. Differential gear
D Using similar procedure to the above, set dial gauge tip to
D Move gear up and down by hand and read dial gauge.
3) If thrust play is out of specification, select suitable thrust washer
from among following available size, install it and check again
that specified gear play is obtained.
4) Drive in spring pin for differential side pinion shaft till it comes
at the position with differential case surface as shown in figure.
Special Tool
(C): 09922-85811
Spring pin depth "a": 9 mm (0.35 in.)
1. Differential case
2. Differential gear
3. Differential pinion
shaft
4. Spring pin
5) Press-fit these bearings into differential case by using special
tool. Driving bearing into the case is not permitted.
Special Tool
(D): 09940-53111
gear shoulder.
Available thrust washer
thickness
DIFFERENTIAL 7F-11
0.9, 1.0, 1.1 and 1.2 mm
(0.035, 0.039, 0.043 and 0.047 in.)