Caliper Assembly - Suzuki GA413 Service Manual

1. E-ring

CALIPER ASSEMBLY

REMOVAL
1) Hoist vehicle and remove wheel.
2) Remove E-ring.
3) Loosen flexible hose union bolt a little at caliper.
4) Remove caliper pin bolts.
5) Remove caliper from carrier.
6) Disconnect flexible hose from caliper by using care not to twist
1. Caliper
it. As this will allow fluid to flow out of flexible hose, have a con-
2. Caliper pin bolt
tainer ready beforehand.
3. Disc
DISASSEMBLY
Before disassembly, clean all around caliper with brake fluid.
1) Blow compressed air into cylinder through bolt hole where flex-
ible hose was fitted. With this air pressure, piston can be pushed
out of cylinder.
1. Cloth
CAUTION:
Be careful not to twist flexible hose while loosening
the bolt.
WARNING:
Do not apply too highly compressed air which will
cause piston to jump out of cylinder. It should be tak-
en out gradually with moderately compressed air. Do
not place your fingers in front of piston when using
compressed air.
BRAKES 5-33