Suzuki GA413 Service Manual page 153

3D-8 FRONT SUSPENSION
1. Compression rod lock nut
2. Compression rod stud nuts
1. Compression rod bracket bolts
2. Compression rod bracket
: Use new nut
1. Compression rod bracket
bolts
2. Compression rod bracket
3. Compression rod bushings
4. Compression rod washer
3. Compression rod
4. Suspension arm
5. Compression rod lock nut
6. Compression rod stud nuts
7. Compression rod
8. Suspension control arm
9. Compression rod front
washer
COMPRESSION ROD AND/OR BUSHINGS
REMOVAL
1) Hoist vehicle, allow front suspension to hang free.
2) Remove stabilizer bar, refer to steps 2) to 4) of STABILIZER
BAR AND/OR BUSHINGS REMOVAL.
3) Remove compression rod nuts.
4) Remove compression rod.
5) Remove compression rod bracket from vehicle body.
INSTALLATION
Install in reverse order of removal procedure, noting the following
points.
D For correct installation of compression rod bushings and com-
pression rod washers, refer to the left figure.
D Use new compression rod lock nuts.
D Tighten each bolts and nuts to specified torque.
Tightening Torque
(a): 55 N·m (5.5 kg-m, 40.0 lb-ft)
(b): 65 N·m (6.5 kg-m, 47.0 lb-ft)
(c): 95 N·m (9.5 kg-m, 69.0 lb-ft)