Suzuki GA413 Service Manual page 232

5-36 BRAKES
"A" : Apply rubber grease
INSTALLATION
1) Before installing caliper (cylinder body) to carrier, check to en-
sure that cylinder slide pin inserted in each caliper carrier hole
can be moved smoothly in thrust direction.
Apply rubber grease to slide pin.
NOTE:
Where temperature gets as low as – 305C (– 225F) in cold
weather, use rubber grease whose viscosity varies very
little even at – 405C (– 405F).
2) Install caliper to caliper carrier.
Tighten caliper pin bolts to specified torque.
NOTE:
Make sure that boots are fit into groove securely.
Tightening Torque
(a): 27 N·m (2.7 kg-m, 19.5 lb-ft)
1. Caliper
2. Caliper pin bolt
3. Disc
3) Tighten union bolt to specified torque.
Tightening Torque
(b): 23 N·m (2.3 kg-m, 17.0 lb-ft)
4) Install E-ring to strut securely.
5) Lower hoist.
6) Tighten wheel nuts to specified torque.
7) After completing installation, fill reservoir with brake fluid and
bleed air from brake system. Perform brake test and check each
installed part for oil leakage.
1. Union bolt
2. Washer
3. E-ring
WARNING:
Make sure that flexible hose is not twisted when tight-
ening joint bolt. If it is twisted, reconnect it using care
not to twist it.