Suzuki GA413 Service Manual page 136

3C-8 STEERING WHEEL AND COLUMN
1. Align marks
CENTERING CONTACT COIL (FOR VEHICLE WITH
AIR BAG SYSTEM)
1) Check that vehicle's wheels (front tires) are set at straight-
ahead position.
2) Check that ignition switch is at "LOCK" position.
3) Turn contact coil counterclockwise slowly with a light force till
contact coil will not turn any further.
NOTE:
Contact coil can turn about 5 turns at maximum, that is, if
it is at the center position, can turn about two and a half
turns both clockwise and counterclockwise.
4) From the position where contact coil became unable to turn any
further (it stopped), turn it back clockwise about two and a half
rotations and align center mark with alignment mark.
COMBINATION SWITCH/CONTACT COIL
AND COMBINATION SWITCH ASSEMBLY
CAUTION:
For vehicle with air bag system
Do not turn contact coil (on combination switch) more
than allowable number of turns (about two and a half
turns from the center position clockwise or counter-
clockwise respectively), or coil will break.
REMOVAL
1) Remove steering wheel from steering column. Refer to RE-
MOVAL of STEERING WHEEL in this section.