Suzuki GA413 Service Manual page 535

6H-20 CHARGING SYSTEM
1. End housing bearing
2. Rotor
1. Stud bolt 3. Drive end bearing
2. Retaining plate 4. Stator
1. Rotor
3. Bearing cover
2. Drive end frame
ASSEMBLY
1) If end housing bearing is removed, install it.
2) Check end housing bearing turns smoothly.
3) If stator is removed, install stator and tighten stud bolts.
4) If drive end bearing is removed, install it.
5) Check drive end bearing turns smoothly.
Tightening Torque
.
(a): 8.8 N m (0.88 kg-m, 6.5 lb-ft)
.
(b): 2.6 N m (0.26 kg-m, 2.0 lb-ft)
6) Place space collar and drive end frame on pulley, and then
install rotor to drive end frame.
7) Install rear end frame to drive end frame.
8) Tighten bolts and nuts to specified torque.
Tightening Torque
.
(a): 4.5 N m (0.45 kg-m, 3.5 lb-ft)
9) Install pulley and tighten pulley nut to specified torque.
Tightening Torque
.
(a): 113 N m (11.3 kg-m, 81.5 lb-ft)