Suzuki GA413 Service Manual page 218

5-22 BRAKES
FLUID PRESSURE TEST (if equipped with
LSPV)
Test procedure for LSPV assembly is as follows.
Before testing, confirm the following.
D Fuel tank is filled with fuel fully.
D Vehicle is equipped with spare tire, tools, jack and jack handle.
1) Install pressure gauges to front and rear brake.
NOTE:
Pressure gauge should be connected to bleeder plug hole
of front (driver's side brake) and rear brakes.
Special Tool
(A) : 09956-02310
(B) : 55473-82030 (Bleeder plug (10 mm) supplied as a
(C) : 09952-46520 (Attachment for rear wheel cylinder)
NOTE:
Special tool (C) is used instead of thread diameter 10mm
attachment included in special tool (A). So remove the at-
tachment from (A) and install (C) for pressure gauge used
1. Air bleeder plug
for rear brake. For front brake caliper, install special tool (A)
2. Weight
3. Attachment without changing its attachment.
2) Place weight (about 90 – 130 kg (200 – 285 Ib)) slowly on rear
floor (axle housing center) so that rear axle weight is measured
as specified.
Depress brake pedal gradually till fluid pressure of front brake
becomes as specified below and check corresponding pres-
sure of rear brake then. It should be within specification given
below.
Front brake line pressure " P
Rear axle weight " L"
TRUCK model
As done above, add weight (about 250 kg (550Ib)) so that rear
axle weight is as specified, and check that rear brake pressure
is within specification as given below.
Rear axle weight " L"
TRUCK model
spare part)
Rear brake "P
VAN model
Rear brake "P
VAN model
" : 10,000 kPa
1
2
(100 kg/cm , 1,422psi)
: 550 kg (1,213 Ib)
"
2
4,000 – 5,400 kPa
2
40 – 54 kg/cm
569 – 768 psi
4,900 – 6,300 kPa
2
49 – 63 kg/cm
697 – 896 psi
: 800 kg (1,764 Ib)
"
2
5,300 – 6,700 kPa
2
53 – 67 kg/cm
754 – 953 psi
5,900 – 7,300 kPa
2
59 – 73 kg/cm
839 – 1,038 psi