Suzuki GA413 Service Manual page 379

8) Install pistons and connecting rods as previously outlined.
9) Install oil pump strainer and oil pan as previously outlined.
10) Install cylinder head assembly to cylinder block as previously
outlined.
NOTE:
Tighten cylinder head bolts to specified torque as pre-
viously outlined and loosen them once till tightening
torque becomes "zero". And then torque them to specifi-
cation again.
11) Install camshaft, crankshaft timing belt pulley, timing belt,
crankshaft pulley, water pump pulley, etc., as previously out-
lined.
12) Install clutch to flywheel. For clutch installation, refer to Section
7C.
13) Combine engine with transmission referring to Section 7A.
14) Install engine and transmission assembly to vehicle as pre-
viously outlined.
ENGINE MECHANICAL 6A-73