Suzuki GA413 Service Manual page 546

8) Remove control cable end clips (1) and washers (2), and then
disconnect gear shift cable (3) and select cable (4) from each
lever.
9) Remove gear shift and select control cables from bracket (5).
10) Remove propeller shaft referring to "PROPELLER SHAFTS"
section.
11) With transmission supported on jack, remove stiffner (1).
12) Remove bolts and nuts fastening engine cylinder block and
transmission case.
NOTE:
Before starting to remove transmission, check around
once again to be sure that there is no connection left un-
done.
13) Remove transmission rear mounting bolt & nut from chassis.
14) Separate transmission from engine and remove clutch hous-
ing upper and lower plates.
15) Take down transmission.
MANUAL TRANSMISSION 7A-7