Suzuki GA413 Service Manual page 958

WASHER TANK AND WASHER PUMP
REMOVAL
1) Disconnect battery (–) cable.
2) Remove washer tank (1) fitting screws.
3) Disconnect pump lead wire coupler and hose.
4) Remove washer tank (1).
5) Remove front washer pump (2) and rear washer pump (3) (if
equipped).
INSPECTION
Connect battery ( + ) and (–) terminals to pump ( + ) and (–) termi-
nals respectively to check pumping rate.
Check for washer pump.
Reference pumping Rate: more than 1.0 l/min
INSTALLATION
Reverse removal procedure for installation.
REAR WIPER AND WASHER SWITCH
(IF EQUIPPED)
INSPECTION
Type 1: In Combination Switch
Check for continuity between terminals at each switch position as
shown below. If check result is not as specified, replace.
Terminal
Position
(1) WIPER and WASHER ON
(2) WIPER ON
(3) OFF
(4) WASHER and WASHER ON
BODY ELECTRICAL SYSTEM 8-7
(2.1 US pt./min, 1.76 Imp pt./min)
IG LO WA