Suzuki GA413 Service Manual page 548

1. Shift cable lever
2. Shift cable lever outer
pin
3. Shift cable lever inner
pin
4. Boot
5. Gear shift shaft oil seal
6. Gear shift guide case
7. Gear shift & select shaft
UNIT REPAIR OVERHAUL
DISASSEMBLING UNIT
GEAR SHIFT & SELECT SHAFT ASSEMBLY
1) To disassembly component parts, use special tools (A) & (B)
2) Clean all parts thoroughly, inspect them and replace with new
3) Assemble component parts by reversing removal procedure.
4) If oil seal is replaced, apply grease to its lip.
8. E-ring
9. Rev. interlock shaft pin
10. 5th-rev. gear shift cam
11. Cam return spring
12. 5th-rev. interlock plate
13. Gear shift & select le-
ver
14. Low select spring
15. Washer
TRANSMISSION CASE
1) Remove clutch release bearing (1) and release fork (2).
2) Remove input shaft bearing retainer bolts and pull out retainer
3) Remove speed sensor from extension case.
and 2.8 – 3.0 mm (0.11 in.) pin remover in addition.
Special Tool
(A): 09922-85811 (4.5 mm)
(B): 09925-78210 (6.0 mm)
ones as required.
"A" : Grease 99000-25010
NOTE:
D When driving in spring pins, prevent shaft from being
bent by supporting it with wood block.
D Assemble 5th & REV gear shift cam by winding cam
guide return spring, and then drive in spring pin.
D Locate low speed select spring (Green) and reverse se-
lect spring (Yellow) correctly.
(3).
Take out oil seal from input shaft bearing retainer as necessary.
MANUAL TRANSMISSION 7A-9