Suzuki GA413 Service Manual page 561

7A-22 MANUAL TRANSMISSION
2. 5th speed hub
10) Install reverse gear needle bearing and reverse gear (1).
11) [In the case of press-fitting hub]
Using special tools, puller and hydraulic press, drive in 5th
speed synchronizer sleeve and hub assembly (2) with punch
marked side of hub directed to forward (reverse gear side).
NOTE:
D Hold reverse gear in its installing position by hand to
prevent washer and ball from dropping off.
D Check free rotation of reverse gear after press-fitting
sleeve and hub assembly.
Special Tool
(A): 09924-07720
(B): 09924-07710
[In the case of loose-fitting hub]
Install 5th speed synchronizer sleeve and hub assembly (2)
with punch marked side of hub directed forward (reverse gear
side).
12) If 5th speed sleeve and hub assembly is press-fitted, ensure
that components are free from iron filings shaved off by press-
fitting.
Remove any iron filings from around the areas concerned by
using compressed air, if necessary.
13) Fit 5th speed hub circlip (1) into groove in main shaft.
14) Install 5th gear needle bearing, 5th gear synchronizer ring and
5th gear.