7A-26 MANUAL TRANSMISSION
3. Lower case
3) Press-fit reverse gear (1) and then 5th gear (2).
NOTE:
When press-fitting, hold countershaft with its front end set
on wood blocks.
Special Tool
(A): 09913-80113
4) After press-fitting countershaft rear bearing (1), make sure to fit
circlip securely.
NOTE:
When press-fitting, hold countershaft with its front end set
on wood blocks.
Special Tool
(A): 09913-80113
5) Install reverse idle gear (3) and washer onto reverse gear shaft
and pin (1) into it.
Install above as assembled into lower case with pin and washer
tongue (2) aligned as shown.
6) Fit circlip (1) around bearing and check to make sure that circlip
just contacts with case surface.
2. Front bearing