Suzuki GA413 Service Manual page 559

7A-20 MANUAL TRANSMISSION
[A]: Center bearing side
4) If low speed sleeve and hub assembly is press-fitted, ensure
that components are free from iron filings shaved off by press-
fitting.
Remove any iron filings from around the areas concerned by us-
ing compressed air, if necessary.
5) Fit low speed hub circlip (1) into groove in main shaft.
6) Install low gear needle bearing, synchronizer ring, low gear, ball
and washer onto main shaft.
Fit ball into hole in shaft and install washer so that its slot (1)
comes over ball (3).
To direct washer correctly, bring its circumference chamfered
side (2) to main shaft center bearing.
7) Press-fit center bearing (1) with special tools.
NOTE:
Hold washer (2) by hand while press-fitting to prevent
washer and ball (3) from dropping off.
Special Tool
(A): 09924-07720
(B): 09924-07710
C: Low gear side