Suzuki GA413 Service Manual page 318

6A-12 ENGINE MECHANICAL
4) Remove air intake hose.
5) Disconnect following electric lead wires:
D EGR valve (if equipped)
D Ground wires from intake manifold
D Engine coolant temperature sensor
D Injectors lead wires at the coupler
D EVAP canister purge valve
D Throttle position sensor
D Idle air control valve
D MAP sensor
D Engine oil pressure switch
D CMP sensor
D Heated oxygen sensor (if equipped)
and release wire harness from clamp.
6) Disconnect accelerator cable from throttle body.
7) Disconnect following hoses:
D Brake booster hose from intake manifold
D Canister purge hose from EVAP canister purge valve
D Heater inlet hose from throttle body
D Radiator inlet hose and reservoir hose from thermostat cap
D PCV hoses from intake manifold and throttle body
D Fuel feed hose and return hose from each pipe
NOTE:
ALPHABET in the figure shows where each hose is con-
nected.
8) Remove intake manifold with throttle body from cylinder head,
and then its gasket.