Suzuki GA413 Service Manual page 652

9-16 BODY SERVICE
WINDSHIELD
The windshield is installed by using a special type of adhesive (that
is, one component urethane adhesive used with primer). For wind-
shield glass replacement, it is important to use an adhesive which
provides sufficient adhesion strength and to follow the proper pro-
cedure.
CAUTION:
D Described in this section is the glass replacement by
using 2 types of primers and 1 type of adhesive made
by YOKOHAMA (one component urethane adhesive to
be used with primer in combination). When using
primer and adhesive made by other manufacturers, be
sure to refer to handling instructions supplied with
them. Negligence in following such procedure or mis-
use of the adhesive in any way hinders its inherent
adhesive property. Therefore, before the work, make
sure to read carefully the instruction and description
given by the maker of the adhesive to be used and be
sure to follow the procedure and observe each precau-
tion throughout the work.
D Should coated surface be scratched or otherwise
damaged, be sure to repair damaged part, or corrosion
may start from there.
Use an adhesive of above mentioned type which has following
property.
Shearing strength: 40 kg/cm
1. Windshield
2. Molding
3. Windshield trim
4. Spacer
5. Stopper
2 2
(569 lb/in ) or more