Suzuki GA413 Service Manual page 639

1. Cloth
2. Regulator handle
1. Sash
2. Glass run
3. Window regulator
4. Door glass
1. Attaching screw
2. Window regulator assembly
FRONT DOOR GLASS AND WINDOW REGULATOR
REMOVAL
1) Remove window regulator handle (if equipped).
For its removal, pull off snap by using a cloth as shown.
2) Lower door glass fully.
3) Remove screw and then inside handle assembly from door
trim by sliding it forward.
4) Remove door inner weatherstrip (if equipped).
5) Remove door mirror garnish and clips.
6) Remove inside lock knob, door handle or armrest fitting screw
(if necessary).
7) With inside handle bezel tilted as shown in the figure, turn door
trim 905 to remove it.
And disconnect power window switch lead wire at coupler (if
equipped).
8) Remove door sealing cover.
9) Remove glass run rear part.
10) Remove glass bottom channel attaching screws.
11) Take out door glass.
12) Remove window regulator attaching screws (six pcs.).
Then, take out regulator through hole "A".
BODY SERVICE 9-3