Suzuki GA413 Service Manual page 569

7A-30 MANUAL TRANSMISSION
1. Input shaft bearing retainer
INPUT SHAFT BEARING RETAINER
1) Install new oil seal (1) with special tool and hammer up to case
surface, apply grease to oil seal lip.
Special Tool
(A): 09913-75820
(B): 09941-34513-004
"A": Grease 99000-25010
2) Clean surface of retainer (2) to mate with transmission case and
uniformly apply sealant.
Sealant 99000-31110
3) Tighten retainer bolts to specification.
Tightening Torque
(a): 23 N·m (2.3 kg-m, 17.0 lb-ft)
4) Check transmission input shaft for easy rotation by hand.
5) Check each select and shift shaft for operation.
CLUTCH RELEASE BEARING
Before installing bearing, apply grease to inner surface of clutch re-
lease bearing. For detail, refer to "CLUTCH" section.
INPUT SHAFT
Before remounting transmission ass'y to engine and vehicle, apply
grease to input shaft.
"A": Grease 99000-25210