Wheel Cylinder - Suzuki GA413 Service Manual

1. Shoe hold down pins
2. Shoe hold down springs
3. Shoe return lower spring
1. Apply rubber grease
4. Shoe return upper spring
5. Adjuster lever
6. Adjuster spring
1. Flare nut
Springs
Inspect for damage, corrosion or weakening.
Inspect each part with arrow for rust. If found defective, replace.
Parking Shoe Lever
Inspect brake shoe lever for smooth movement along shoe rim. If
defective, correct or replace.
INSTALLATION
Assemble parts in reverse order of removal.
NOTE:
Removed retainer ring should be replaced with new one.
1) Apply rubber grease to brake back plate and parking brake
shoe lever as shown in figure.
2) Install shoe hold down springs by pushing them down in place
and turning hold down pins.
3) Install shoe return spring, adjuster lever and adjuster spring.
4) For procedure hereafter, refer to steps 1) to 6) of BRAKE DRUM
INSTALLATION.

WHEEL CYLINDER

REMOVAL
1) Perform steps 1) to 6) of BRAKE DRUM REMOVAL.
2) Perform steps 2) to 4) of BRAKE SHOE REMOVAL.
3) Loosen brake pipe flare nut but only within the extent that fluid
does not leak.
BRAKES 5-41