Ip Interface Commands; Basic Ip Configuration - SMC Networks SMC6724L3 Management Manual

IP Interface Commands

There are no IP addresses assigned to this router by default. You must
manually configure a new address to manage the router over your network
or to connect the router to existing IP subnets. You may also need to a
establish a default gateway between this device and management stations
or other devices that exist on another network segment (if routing is not
enabled).
This section includes commands for configuring IP interfaces, the Address
Resolution Protocol (ARP) and Proxy ARP. These commands are used to
connect subnetworks to the enterprise network.
Command Group
Basic IP
Configuration
Address Resolution
Protocol (ARP)

Basic IP Configuration

Command
ip address
ip default-gateway Defines the default gateway through which this
show ip interface
show ip redirects
ping
Function
Configures the IP address for interfaces and the
gateway router
Configures static, dynamic and proxy ARP service
Function
Sets the IP address for the current interface
router can reach other subnetworks
Displays the IP settings for this device
Displays the default gateway configured for
this device
Sends ICMP echo request packets to another
node on the network
IP I C
NTERFACE
Mode Page
IC
GC
PE
PE
NE,
PE
OMMANDS
Page
4-215
4-221
4-216
4-218
4-219
4-219
4-220
4-215