Negotiation - SMC Networks SMC6724L3 Management Manual

Command Usage
• To force operation to the speed and duplex mode specified in a
speed-duplex command, use the no negotiation command to disable
auto-negotiation on the selected interface.
• When using the negotiation command to enable auto-negotiation, the
optimal settings will be determined by the capabilities command. To
set the speed/duplex mode under auto-negotiation, the required mode
must be specified in the capabilities list for an interface.
Example
The following example configures port 5 to 100 Mbps, half-duplex
operation.
Console(config)#interface ethernet 1/5
Console(config-if)#speed-duplex 100half
Console(config-if)#no negotiation
Console(config-if)#
Related Commands

negotiation (4-121)

capabilities (4-122)
negotiation
Use this command to enable autonegotiation for a given interface. Use the
no form to disable autonegotiation.
Syntax
negotiation
no negotiation
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
I C
NTERFACE OMMANDS
4-121