Configuring Dvmrp Interface Settings; Command Attributes - SMC Networks SMC6724L3 Management Manual

CLI – This sets the global parameters for DVMRP and displays the
current settings.
Console(config)#router dvmrp
Console(config-router)#probe-interval 30
Console(config-router)#nbr-timeout 40
Console(config-router)#report-interval 90
Console(config-router)#flash-update-interval 10
Console(config-router)#prune-lifetime 5000
Console(config-router)#default-gateway 10.1.0.253
Console(config-router)#end
Console#show router dvmrp
Admin Status
Probe Interval
Nbr expire
Minimum Flash Update Interval
prune lifetime
route report
Default Gateway
Console#

Configuring DVMRP Interface Settings

To fully enable DVMRP, you need to enable multicast routing globally for
the router (page 3-219), enable DVMRP globally for the router
(page 3-223), and also enable DVMRP for each interface that will
participate in multicast routing.

Command Attributes

DVMRP Interface Information
• Interface – VLAN interface on this router that has enabled DVMRP.
• Address – IP address of this VLAN interface.
• Metric – The metric for this interface used to calculate distance vectors.
• Status – Shows that DVMRP is enabled on this interface.
DVMRP Interface Settings
• VLAN – Selects a VLAN interface on this router.
• Metric – Sets the metric for this interface used to calculate distance
vectors.
M
: enable
: 10
: 35
: 5
: 7200
: 60
:
R
ULTICAST OUTING
4-291
4-292
4-293
4-293
4-294
4-294
4-295
4-298
3-227