SMC Networks SMC6724L3 Management Manual page 186

C
ONFIGURING THE
• Act as IGMP Querier — When enabled, the switch can serve as the
Querier, which is responsible for asking hosts if they want to receive
multicast traffic. (Default: Disabled)
• IGMP Query Count — Sets the maximum number of queries issued for
which there has been no response before the switch takes action to drop
a client from the multicast group. (Range: 2-10, Default: 2)
• IGMP Query Interval — Sets the frequency at which the switch sends
IGMP host-query messages. (Range: 60-125 seconds, Default: 125)
• IGMP Report Delay — Sets the time between receiving an IGMP
Report for an IP multicast address on a port before the switch sends an
IGMP Query out of that port and removes the entry from its list. (Range:
5-30 seconds, Default: 10)
• Query Timeout — The time the switch waits after the previous querier
stops before it considers the router port (i.e., the interface which had
been receiving query packets) to have expired. (Range: 300-500 seconds,
Default: 300)
• IGMP Version — Sets the protocol version for compatibility with other
devices on the network. (Default: 2, Range: 1 - 2)
Notes: 1. All systems on the subnet must support the same version.
2. Some attributes are only enabled for IGMPv2, including
Web – Click IGMP Snooping, IGMP Configuration. Adjust the IGMP
settings required, and click Apply. (The default settings are shown below.)
3-138
S
WITCH
IGMP Report Delay and IGMP Query Timeout.