SMC Networks SMC6724L3 Management Manual page 178

C
ONFIGURING THE
Web – Click Priority, IP DSCP Priority. Select a port or trunk from the
Interface field. Select an entry from the DSCP table, enter a value in the
Class of Service Value field, then click Apply.
* Mapping specific values for IP DSCP is implemented as an interface configuration
command, but any changes will apply to the all interfaces on the switch.
CLI – The following example globally enables DSCP Priority service on
the switch, maps DSCP value 0 to CoS value 1 (on port 1), and then
displays the DSCP Priority settings.
Console(config)#map ip dscp
Console(config)#interface ethernet 1/1
Console(config-if)#map ip dscp 1 cos 0
Console(config-if)#end
Console#show map ip dscp ethernet 1/5
DSCP mapping status: disabled
Port
--------- ---- ---
Eth 1/ 1
Eth 1/ 1
Eth 1/ 1
Eth 1/ 1
. .
. Eth 1/ 1
Eth 1/ 1
Eth 1/ 1
Console#
* Mapping specific values for IP DSCP is implemented as an interface configuration
command, but any changes will apply to the all interfaces on the switch.
3-130
S
WITCH
DSCP COS
0 0
1 0
2 0
3 0
61 0
62 0
63 0
4-191
4-119
4-191
4-195