Snmp-Server Enable Traps; Default Setting - SMC Networks SMC6724L3 Management Manual

C L
OMMAND INE
• However, some notification types cannot be controlled with the
snmp-server enable traps command. For example, some notification
types are always enabled.
Example
Console(config)#snmp-server host 10.1.19.23 batman
Console(config)#
Related Commands

snmp-server enable traps (4-94)

snmp-server enable traps
Use this command to enable this device to send Simple Network
Management Protocol traps (SNMP notifications). Use the no form to
disable SNMP notifications.
Syntax
snmp-server enable traps [authentication | link-up-down]
no snmp-server enable traps [authentication | link-up-down]
• authentication - Keyword to issue authentication failure traps.
• link-up-down - Keyword to issue link-up or link-down traps.
The link-up-down trap can only be enabled/disabled via the CLI.

Default Setting

Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
• If you do not enter an snmp-server enable traps command, no
notifications controlled by this command are sent. In order to
configure this device to send SNMP notifications, you must enter at
least one snmp-server enable traps command. If you enter the
command with no keywords, both authentication and link-up-down
4-94
I
NTERFACE