Setting The Switch's Ip Address - SMC Networks SMC6724L3 Management Manual

Web – Click System, Bridge Extension.
CLI – Enter the following command.
Console#show bridge-ext
Max support vlan numbers: 255
Max support vlan ID: 4094
Extended multicast filtering services: No
Static entry individual port: Yes
VLAN learning: IVL
Configurable PVID tagging: Yes
Local VLAN capable: No
Traffic classes: Enabled
Global GVRP status: Disabled
GMRP: Disabled
Console#

Setting the Switch's IP Address

This section describes how to configure an initial IP interface for
management access over the network. The IP address for this switch is
unassigned by default. To manually configure an address, you need to
change the switch's default settings (IP address 0.0.0.0 and netmask
255.0.0.0) to values that are compatible with your network. You may also
need to a establish a default gateway between the switch and management
stations that exist on another network segment (if routing is not enabled
on this switch).
B C
ASIC ONFIGURATION
4-176
3-17