SMC Networks SMC6724L3 Management Manual page 29

Tigerswitch 10/100 24-port layer 3 switch
Hide thumbs Also See for SMC6724L3:
Table of Contents

Advertisement

D
S
F
ESCRIPTION OF
OFTWARE
EATURES
IP Routing – The switch provides Layer 3 IP routing. To maintain a high
rate of throughput, the switch forwards all traffic passing within the same
segment, and routes only traffic that passes between different
subnetworks. The wire-speed routing provided by this switch lets you
easily link network segments or VLANs together without having to deal
with the bottlenecks or configuration hassles normally associated with
conventional routers.
Routing for unicast traffic is supported with the Routing Information
Protocol (RIP) and the Open Shortest Path First (OSPF) protocol.
RIP – This protocol uses a distance-vector approach to routing. Routes are
determined on the basis of minimizing the distance vector, or hop count,
which serves as a rough estimate of transmission cost.
OSPF – This approach uses a link state routing protocol to generate a
shortest-path tree, then builds up its routing table based on this tree. OSPF
produces a more stable network because the participating routers act on
network changes predictably and simultaneously, converging on the best
route more quickly than RIP.
Address Resolution Protocol – The switch uses ARP and Proxy ARP to
convert between IP addresses and MAC (i.e., hardware) addresses. This
switch supports conventional ARP, which locates the MAC address
corresponding to a given IP address. This allows the switch to use IP
addresses for routing decisions and the corresponding MAC addresses to
forward packets from one hop to the next. You can configure either static
or dynamic entries in the ARP cache.
Proxy ARP allows hosts that do not support routing to determine the
MAC address of a device on another network or subnet. When a host
sends an ARP request for a remote network, the switch checks to see if it
has the best route. If it does, it sends its own MAC address to the host. The
host then sends traffic for the remote destination via the switch, which
uses its own routing table to reach the destination on the other network.
1-7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SMC6724L3 and is the answer not in the manual?

Questions and answers

Table of Contents