Ip Switching - SMC Networks SMC6724L3 Management Manual

IP Switching

IP Switching (or packet forwarding) encompasses tasks required to
forward packets for both Layer 2 and Layer 3, as well as traditional routing.
These functions include:
• Layer 2 forwarding (switching) based on the Layer 2 destination MAC
address
• Layer 3 forwarding (routing):
- Based on the Layer 3 destination address
- Replacing destination/source MAC addresses for each hop
- Incrementing the hop count
- Decrementing the time-to-live
- Verifying and recalculating the Layer 3 checksum
If the destination node is on the same subnetwork as the source network,
then the packet can be transmitted directly without the help of a router.
However, if the MAC address is not yet known to the switch, an Address
Resolution Protocol (ARP) packet with the destination IP address is
broadcast to get the destination MAC address from the destination node.
The IP packet can then be sent directly with the destination MAC address.
If the destination belongs to a different subnet on this switch, the packet
can be routed directly to the destination node. However, if the packet
belongs to a subnet not included on this switch, then the packet should be
sent to a router (with the MAC address of the router itself used as the
destination MAC address, and the destination IP address of the destination
node). The router will then forward the packet to the destination node via
the correct path. The router can also use the ARP protocol to find out the
MAC address of the destination node of the next router as necessary.
Note: In order to perform IP switching, the switch should be recognized
by other network nodes as an IP router, either by setting it as the default
gateway or by redirection from another router via the ICMP process.
When the switch receives an IP packet addressed to its own MAC address,
the packet follows the Layer 3 routing process. The destination IP address
is checked against the Layer 3 address table. If the address is not already
IP R
OUTING
3-151