Ip Interface Commands; Ip Address; Table 4-69 Ip Interface Command Syntax - SMC Networks 6824MPE INT Management Manual

C L
OMMAND INE

IP Interface Commands

There are no IP addresses assigned to this switch by default. You must
manually configure a new address to manage the switch over your network.
You may also need to a establish a default gateway between this device and
the management stations.
Command

ip address

ip
default-gateway
ip dhcp restart
show ip interface Displays the IP settings for this device
show ip redirects Displays the default gateway configured for this
ping
ip address
Use this command to set the IP address for the currently selected VLAN
interface. Use the no form to restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp}
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.
4-272
I
NTERFACE

Table 4-69 IP Interface Command Syntax

Function
Sets the IP address for the current interface
Defines the default gateway through which an
in-band management station can reach this
device
Submits a BOOTP or DCHP client request
device
Sends ICMP echo request packets to another
node on the network
Mode Page
IC 4-272
GC 4-274
PE 4-275
PE 4-275
PE 4-276
NE, 4-276
PE