Dvmrp Multicast Routing Commands; Mode Page - SMC Networks SMC6724L3 Management Manual

C L
OMMAND INE
This example lists all entries in the multicast table in summary form:
Console#show ip mroute summary
IP Multicast Forwarding is enabled.
IP Multicast Routing Table (Summary)
Flags: P - Prune UP
Group
--------------- --------------- --------------- ---------- ------- ------
224.1.1.1
224.2.2.2
Console#

DVMRP Multicast Routing Commands

Command
router dvmrp
probe-interval
nbr-timeout
report-interval
flash-update-interval Sets the interval for sending updates about
prune-lifetime
default-gateway
ip dvmrp
ip dvmrp metric
clear ip dvmrp route Clears all dynamic routes in the multicast
show router dvmrp
4-290
I
NTERFACE
Source
10.1.0.0
10.1.0.0
Function
Enables DVMRP and enters router
configuration mode
Sets the interval for sending neighbor probe
messages
Sets the delay before declaring an attached
neighbor router down
Sets the interval for propagating the
complete set of routing tables to other
neighbor routers
changes to network topology
Defines how long a prune state remains in
effect for a source-routed multicast tree
Configures the default gateway for IP
multicast routing
Enables DVMRP on the specified interface IC
Sets the metric used when establishing
reverse paths to some networks on directly
attached interfaces
routing table
Displays global DVMRP configuration
settings
Source Mask Interface
255.255.0.0
255.255.0.0
Owner Flags
vlan1 DVMRP
vlan1 DVMRP

Mode Page

GC 4-291
RC 4-292
RC 4-293
RC 4-293
RC 4-294
RC 4-294
RC 4-295
4-296
IC 4-297
PE 4-298
NE, 4-298
PE
P
--